Looking to add a little bit more power to your Abarth?  Our new Speedmotive Accesspass OBD flash tuning option for your Fiat 500 Abarth will fill your needs, both in performance,drivability and durability. Our approach to this tune was being able to offer a significant boost in power without adding extra stress to the drivetrain components. The result is a noticable increase in power with a linear power delivery.

• Easy to use OBD2 Flash Tuning Hardware
• Based on OEM Software,Maps and Protocols
• Each new file is custom calibrated to your individual ECU and VIN number
• Smooth, linear power delivery
• Flashing procedure protects against incomplete/incompatible flashes
• 91 Octane minimal fuel requirement
• No physical removal of ECU is required
• Tune files that blend both performance and drivability, yet keep failsafes in place for engine safety and durability.
• Low owner transfer fee of $289 should you decide to sell your device to another owner

Power ratings 

Measured at the crank

Stock - 160 hp and 170 tq

Tuned - 208 hp  and 233 tq 

Measured at the wheels

Stock - 138 whp and 145 wtq

Tuned - 186 whp and 208 wtq

Gains over stock  +48 hp and  +63 tq

Suggested aftermarket add-ons - An intake with an open air filter element

Hardware

The Powergate 3 OBD programmer is the innovative and versatile solution to communicate with all kinds of vehicles.

The Powergate 3 is a hand held personal remapping tool that allows the user to read the tuning file on their vehicle, have that modified by us and then upload the new tuning file to their vehicle to see substantial improvements in performance and driveability.

The Powergate 3 can store, in addition to the original file, many different mappings: in this way, the user always has the option to choose the most suitable map to program the ECU safely. It is a safe tool, because it checks whether it is possible to complete the job before starting it. In the event of anomalies, it does not start the procedure.

The Powergate 3 also has a Diagnostic function, which you can use to read and clear and DTC’s (Diagnostic Trouble Codes) and we recommend you run this after each programming session.

Important – It is essential that your vehicle battery is in a good state of charge before programming – if in any doubt connect a charger. Please also ensure that headlights, interior lights, heater fan and radio are all switched off.

Please download and install our PWG3 software to your PC computer. This will allow you to transfer files from your computer to the handheld.

hideDownload Software